Latihan tambahan

比较大小 = banding 位数不同就先补 0，再从十分位比。十分位分出大小后，就不必看百分位。 例子：0.4 和 0.33 → 0.40 和 0.33 → 4 > 3 → 0.4 大。 注意：两位小数不一定比一位小数大，不能看数字多少来判断。

which is greater = banding If the numbers of places differ, add a 0 first, then compare from the tenths. Once the tenths differ, the hundredths do not matter. Example: 0.4 and 0.33 → 0.40 and 0.33 → 4 > 3 → 0.4 is greater. Watch out: a two-place decimal is not always bigger than a one-place decimal; do not judge by the number of digits.

找较小的数 = yang lebih kecil 先补 0，让两个数都有两位小数。十分位相同时，就比百分位，百分位小的那个数比较小。 例子：0.4 和 0.47 → 0.40 和 0.47 → 百分位 0 < 7 → 0.4 比较小。 注意：题目问“比较小”，选之前再读一次题目。

the smaller number = yang lebih kecil Add a 0 first so both numbers have two decimal places. If the tenths are the same, compare the hundredths; the one with the smaller hundredths digit is smaller. Example: 0.4 and 0.47 → 0.40 and 0.47 → hundredths 0 < 7 → 0.4 is smaller. Watch out: the question asks for the smaller one, so read it again before you choose your answer.

比较质量 = banding jisim 比较两包东西哪一包重，就是比较两个小数。单位相同（都是 kg），可以直接比数字：先补 0，再从十分位比。 例子：0.7 kg 和 0.69 kg → 0.70 > 0.69 → 0.7 kg 比较重。 注意：比较之前，先确认两个数的单位一样。

comparing mass = banding jisim Finding the heavier packet means comparing two decimals. The units are the same (both kg), so compare the numbers directly: add a 0 first, then compare from the tenths. Example: 0.7 kg and 0.69 kg → 0.70 > 0.69 → 0.7 kg is heavier. Watch out: before comparing, make sure the two amounts use the same unit.

在前面 = terletak sebelum 数线上“在前面”就是在左边，数值比较小；“在后面”就是在右边，数值比较大。 例子：在 0.35 前面的数有 0.34、0.33 等。 注意：不要把“前面”看成右边，数线是从左往右变大的。

comes before = terletak sebelum On a number line, a number that comes before another lies to its left and has a smaller value; one that comes after lies to the right and is bigger. Example: numbers before 0.35 include 0.34 and 0.33. Watch out: before does not mean to the right; the values grow from left to right.

用格数比较 = banding dengan bilangan petak 把两个小数都想成百格图上要涂的格数：格数多的比较大，格数少的比较小，格数一样就用等号。 例子：0.2 ○ 0.25 → 20 格和 25 格 → 选 <。 注意：不要因为某个数写出来的数字比较多，就认定它比较大。

compare by counting squares = banding dengan bilangan petak Think of each decimal as the number of squares it colours on a hundred square: more squares means greater, fewer means smaller, and the same number means the sign is =. Example: 0.2 ○ 0.25 → 20 squares and 25 squares → choose <. Watch out: do not decide a number is greater just because it is written with more digits.

三个数比较 = banding tiga nombor 三个小数一起比较时，先全部补成两位小数，上下对齐，再从十分位开始比。十分位最大的那个最长；十分位相同，才看百分位。 例子：0.4 m、0.36 m、0.08 m → 0.40、0.36、0.08 → 0.4 m 最长。 注意：只看百分位上的数字大不大，会选错。

comparing three numbers = banding tiga nombor To compare three decimals, write them all with two places, line them up, and start at the tenths. The one with the biggest tenths digit is the longest; only if the tenths match do you look at the hundredths. Example: 0.4 m, 0.36 m, 0.08 m → 0.40, 0.36, 0.08 → 0.4 m is the longest. Watch out: looking only at how big the hundredths digit is leads to the wrong choice.